[quagga-dev 7373] Re: Quagga 1.0?

Joakim Tjernlund joakim.tjernlund at transmode.se
Wed Nov 18 22:02:52 GMT 2009


Bartek Kania <mrbk at gnarf.org> wrote on 18/11/2009 20:43:36:
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA256
>
> On Tue, 17 Nov 2009, Joakim Tjernlund wrote:
> > Bartek Kania <mrbk at gnarf.org> wrote on 16/11/2009 21:02:03:
> >> On Mon, 16 Nov 2009, Joakim Tjernlund wrote:
> >>>> And it logs the error you added. I've attached the log as
> >>>> log.txt. IPnumbers obscured tho.
> >>>> I've also attached my config and the full output from valgrind.
> >>> Can you remove  ip ospf message-digest-key 3 md5 .. part and try again?
> >>> I think it is a bit strange the my log msg triggers, these ptr
> >>> should be the same as I read the code.
> >> Removing md5 key doesn't seem to to help...
> > Did you try routerID != any IP address?
>
> I did, right now...
> If I omit the router-id parameter then ospfd has problems and crashes.
>
> If I specify a router-id, then everything is great. It doesn't matter
> which IP I specify. Even if I set exactly the same as ospfd chose by
> itself.
>
> So, without router-id set a "sh ip ospf" shows
>      OSPF Routing Process, Router ID: x.y.A.56
> and ospfd crashes, and valgrind complains about double frees.
>
> Now if I add router-id x.y.A.56 to the config, everything is great...

Was that:
router ospf
  router-id x.y.A.56
?
what if you set router-id in zebra instead?




More information about the Quagga-dev mailing list