[quagga-dev 9951] [PATCH 3/3] doc: update installation instructions

David Lamparter equinox at opensourcerouting.org
Sat Nov 3 18:24:28 GMT 2012


configure parameters have changed quite a bit, several options are
enabled by default now and there's --disable-tests.  Update
documentation to match.

Signed-off-by: David Lamparter <equinox at opensourcerouting.org>
---
 doc/install.texi |   18 ++++++++++++------
 1 files changed, 12 insertions(+), 6 deletions(-)

diff --git a/doc/install.texi b/doc/install.texi
index 16e29c9..1cc6557 100644
--- a/doc/install.texi
+++ b/doc/install.texi
@@ -79,21 +79,27 @@ file does not match to the current running kernel, configure script will
 not turn on netlink support.
 @item --enable-snmp
 Enable SNMP support.  By default, SNMP support is disabled.
- at item --enable-opaque-lsa
-Enable support for Opaque LSAs (RFC2370) in ospfd.
+ at item --disable-opaque-lsa
+Disable support for Opaque LSAs (RFC2370) in ospfd.
 @item --disable-ospfapi
 Disable support for OSPF-API, an API to interface directly with ospfd.
 OSPF-API is enabled if --enable-opaque-lsa is set.
 @item --disable-ospfclient
 Disable building of the example OSPF-API client.
- at item --enable-ospf-te
-Enable support for OSPF Traffic Engineering Extension (internet-draft) this
+ at item --disable-ospf-te
+Disable support for OSPF Traffic Engineering Extension (internet-draft) this
 requires support for Opaque LSAs.
 @item --enable-multipath=@var{ARG}
 Enable support for Equal Cost Multipath. @var{ARG} is the maximum number
 of ECMP paths to allow, set to 0 to allow unlimited number of paths.
- at item --enable-rtadv
-Enable support IPV6 router advertisement in zebra.
+ at item --disable-rtadv
+Disable support IPV6 router advertisement in zebra.
+ at item --disable-tests
+Do not build tests.  Test programs are built by default, but not ran or
+installed.  They can be excluded from build with this option, which will
+minimally decrease compile time and overhead.  They can always be built and
+executed at a later time by running @command{make check} in the @file{tests/}
+subdirectory, even if they're excluded from build.
 @end table
 
 You may specify any combination of the above options to the configure
-- 
1.7.8.6




More information about the Quagga-dev mailing list